NCast Corporation, 11/05/2009
-------------------------------

Release 2.2.0  (11/05/2009)
Updated releaasenotes (note about 2.1.0 was missing).

Release 2.1.0 (7/20/2009)
1. An option to reverse components in RGB stream for VLC player. Option is available on property page.


Release 2.0.4.
1. Property Page, TAB custom: allowing to setup size in pixels, not only percent of the screen.

Release 2.0.3.
1. Default Capture Resolution.
2. Crossbar Allowed/Disabled.

Release 2.0.2.

1. RGB24 up to UXGA, YUV420 up to WUXGA


Release 2.0.1

1. Two version with and without crossbar are availabe, 
   the one with Crossbar enabled say: "With Crossbar Support Enabled".
2. Fixed firmware update to version 2.00
3. Input switching to make sure GM will detect signal properly.


Release 2.0.0.3 (experimental)

1. Resolution up to WUXGA, 
2. Capture speed limit removed,
3. Fixed property page framerate and resolution report.
4. Review installation files.

Release 2.0.0.2

Crash problem fixed

Release 2.0.0.1

YUV420 Support 


Release 1.1.

1.1.2 (2/27/2006) changes:

1. Support for HW change, for boards, revision 3.

1.1.1 (2/08/2006) changes:

Device name change in .inf file (suffix rev3 rev4 added, because boards revision 3 and revision 4,
are recognized as different devices, and must have different names).


1.1 (11/23/2006) changes:

1. Added support for GSI memory chips.
2. Crossbar functionality removed.
3. Removed "Video Compression Properties" since no compression available.


1.0 (09/20/2006) changes:

1. Basic crossbar functionality addded.



0.9.2.0 (09/01/2006) changes:

1. Firmware update.


0.9.1.0 (08/24/2006) changes:

1. PCI burst transfer.
2. Fixed property page layout.
3. Added Custom tab to property page.


0.9.0.4 (07/17/2006) changes:

1. Updated firmware to version 1.2.
2. Updated property page updated for firmware version 1.2.
3. Changes to property page.
4. Framerate control.
5. Window positioning on start.


0.9.0.3 (06/16/2006) changes:

1. Support for hardware with new device ID.
2. Basic support for firmware version 1.0 and 1.1.


0.9.0.2 (05/25/2006) changes:

1. Default resolution set to 1280x720. 
